Special Price 224 kr Ordinarie pris 299 kr
3 I Lager

Finish-Cure 20 min kan användas till glasfiber eller kolfiberarbeten. Bra alternativ till polyester. Kan även användas för försegling av träytor så de blir beständiga mot bränsle. Även bra för sammanfogning av foamvingar etc. Den lite längre härdningstiden underlättar inpassningen.

FINISH-CURE™ 20 min. epoxy is an excellent, low odor substitute for polyester resins. It can be used for applying fiberglass cloth to wood or by itself to give wood a surface ready for primer and paint. FINISH-CURE™ can be sanded the easiest of all our epoxies and is excellent for the sheeting of foam core wings. Allow 8 hours for full curing. For best results, FINISH-CURE™ should be heated to a temperature above 85 degrees F or applying light weight fiberglass, lay cloth on balsa first, then brush on FINISH-CURE™. When fully saturated, go over the surface with a heat gun, and then squeegee off excess epoxy with a playing card from an old deck. Heat and remove excess several times for a light weight finish. If room temperature is below 70 degrees F use a heat gun on the surface several times for the next 2 hours. When dry, lightly sand, then fill surface with a low weight spakeling compound, scrapping off excess with a playing card. Sand to a smooth finish ready for primer. For heavy weight fiberglass, apply the epoxy before and after laying down the cloth. FINISH-CURE™ is best mixed in a disposable cup.

Mer information
Tillverkare BSI - Bob Smith Industries
- 25%